Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Moen Driveway & Pavers: The Fort Worth Owner’s Guide
Moen driveway and paver components in Fort Worth typically cost $7,000 – $18,000 installed depending on square footage, paver type, and whether we’re repairing a section or rebuilding the full run. We stock Moen-compatible paver edging, joint sand, sealers, and drainage components on our trucks, and we can usually match your existing Moen-laid pattern within one to two visits. Most homeowners discover a problem after a Fort Worth storm: a sunken paver near the garage apron, water pooling against the foundation, or edging that has pulled away and now catches the lawn mower. The good news is that driveway and paver failures are rarely total. We repair what’s failed, match the existing material, and leave the rest of the run alone.
Which Moen Models This Applies To
Moen’s outdoor hardscape line covers a few distinct paver profiles, and the part you need depends on which one you have. The most common in Fort Worth are the 60mm and 80mm concrete pavers, which differ in thickness and load rating, plus the polymer-sand joint system Moen specifies for their permeable installations. Before you call us, flip over a loose paver or check the edge of the driveway. Most Moen pavers carry a raised code on the underside: a three-digit series number followed by the thickness in millimeters. That code tells us whether we’re matching a current production run or a discontinued color, which is the single biggest compatibility gotcha with Moen hardscape. If your pavers were installed more than eight years ago, the color may have been retired, and we’ll need to blend from the closest current shade plus a tinted sealer to make the repair disappear.
On the OEM-versus-aftermarket question: for Moen driveway pavers specifically, we recommend OEM or exact-match where the paver is visible, because aftermarket color variance shows up badly on a driveway. For hidden components like edge restraints and base material, quality aftermarket equivalents are usually fine, and we’ll tell you when they’re the better buy. Elmstead Remodeling Fort Worth is an independent service provider, not affiliated with Moen, but we install and repair their hardscape components regularly enough to know what matches and what doesn’t.
Styles & brands we work with
Signs Your Moen Driveway & Pavers Are Failing
- Sunken or tilted pavers near the garage apron. This usually means the base material has washed out underneath, which happens in Fort Worth when clay soil shifts after heavy rain. Left alone, the paver eventually cracks under vehicle weight.
- Weeds or moss pushing up through the joints. The polymer sand in Moen’s joint system breaks down after five to seven years in Texas sun. Once the sand is gone, seeds get in, roots expand, and the pavers start drifting apart.
- Water pooling against the foundation or garage door. Pavers should slope away at about a quarter inch per foot. When the base settles unevenly, water runs the wrong direction, and that’s when you get foundation staining or a wet garage floor.
- Edging that’s pulled away from the pavement. Fort Worth’s freeze-thaw cycles, mild as they are, still work on plastic edge restraints over time. A gap of even half an inch lets the outer pavers walk outward and opens the whole edge to failure.
- Crumbling or flaking paver surfaces. Moen pavers are sealed at the factory, but after a decade of Texas UV exposure, the seal fails and the surface starts to spall. We see this most often on driveways with full south-facing sun exposure, like those in the TCU area and parts of Wedgwood.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here are the Fort Worth market ranges we work within, using the same numbers we quote on every Elmstead project:
- Paver driveway installation (new or full rebuild): $7,000 – $18,000
- Driveway replacement (remove and re-lay existing pavers): $5,000 – $14,000
- Paver patio installation: $3,500 – $11,000
- Driveway sealing (cleaning plus sealant on existing pavers): $250 – $700
What drives the range is square footage first, then the condition of the base underneath. If the original installer cut corners on the base, we’re rebuilding it, not just replacing the top layer, and that’s a different job. Every quote includes written line-item pricing before any work starts, the pavers or components, base material as needed, joint sand, disposal of the old material, and a photo of the clean-up before the crew leaves. The work carries our 365-Day Done Right Promise: if it’s not done right after the job is complete, we make it right.
DIY or Call Us?
Replacing a single cracked paver is something a careful homeowner can do if the paver lifts out cleanly and the base is still solid. The same goes for refreshing joint sand on a small patio. Where DIY goes wrong is when the base has failed or the drainage slope is off, because that means digging out and recompacting, and Fort Worth clay soil does not forgive a shortcut. If water is running toward your foundation, don’t patch the surface and hope. Call us at (682) 708-9180. Graham Stein will walk the driveway with you, name what he sees, and hand you a written price before a single tool comes off the truck.
FAQs
Moen concrete pavers on a properly built base typically last 20 to 30 years in Fort Worth before the surface needs significant work. The joint sand and sealer won’t last nearly that long: expect to refresh those every five to seven years. Call (682) 708-9180 and we’ll tell you exactly what your driveway needs now, not what a generic maintenance schedule says.
Yes, in most cases. We repair sunken sections by lifting and re-bedding the pavers, which is far less expensive than a full rebuild, as long as the base is still structurally sound. The full replacement range is $5,000 – $14,000; a targeted repair is usually a fraction of that. Call (682) 708-9180 for an exact quote, estimates are free.
Most single-section repairs and paver replacements in Fort Worth are done in one to two working days, assuming the weather cooperates. A full driveway rebuild can run three to five days. We’ll put the timeline in writing before work starts. Call (682) 708-9180 to schedule a walkthrough.
We keep common Moen-compatible edge restraints, polymer joint sand, and sealers on the truck, along with a working inventory of the most common current paver profiles. Discontinued colors or unusual sizes may take a few days to source. Call (682) 708-9180 and we’ll check the underside code on your pavers so we know what we’re matching before we even arrive.
No. The written price and the final invoice should read the same, and if they don’t, that’s on us to explain before we hand you a pen. The only exception is if we uncover a base failure that was hidden under the surface, and even then we stop work and bring you a written change order before we proceed.
When you’re ready to talk through your driveway, call (682) 708-9180. We’re Elmstead Remodeling Fort Worth, a Cedarwell company, and we also stock and install parts for KraftMaid, Cambria, and Silestone products, so if your hardscape repair dovetails into an exterior or interior project, we can handle the whole scope under one written price. Our crews wear shoe covers and lay drop cloths inside the house, keep quiet tools during children’s sleep hours, and choose pet-safe products where there is a choice. A real person answers the phone 24/7, and the estimate is always free.
Written by Graham Stein, Owner, Elmstead Remodeling Fort Worth at Elmstead Remodeling Fort Worth, serving Fort Worth and nearby areas.
